Multimatic Bulk-Feed Design Info

	Head	Air-Flow Direction*
	To Open	In - P1 Out - P2

	To Close	In - P2 Out - P1

	*Use 40 PSI Air Supply




Operational View - Bulk Feed Head in Open Position

Operation

Bulk Pierce Nuts are fed into a Multipierce or Multimatic Head through plastic nut guide from a gravity or power-feed device.

Force transmitted through the nuts in the plastic nut guide places a nut under the nut plunger in the "ready" position and, as the press cycles, the nut is installed. The plunger prevents a new nut from being placed into "ready" position until a signal is received from the part probe, at which time air forces the Head to an "open" position. Until a signal is received from the part probe the Head will remain in the "closed" position, preventing nuts from being placed in the "ready"position. The prevents double hits and potential damage to the die.

Die Design Information

Multimatic Bulk Feed Heads are designed into a die in the same manner as Multipierce and Multimatic Reel-Feed Heads; same access requirements exist.

Refer to Multipierce and Multimatic sections for Head mounting dimensions.

Universal Pierce Nut
Ext.		Shut Height		Open Height		Stroke*		A		B
MM	In	MM	In	MM	In	MM	In	MM	In	MM	In

12.7	0.50	130.2	5.125	161.9	6.375	31.8	1.25	42.8	1.687	25.4	1.00

38.1	1.50	155.6	6.125	212.7	8.375	57.2	2.25	68.2	2.687	50.8	2.00

57.2	2.25	174.6	6.875	250.8	9.875	76.2	3.00	87.3	3.437	69.9	2.75

Home | Site Map | Search

FabriSteel A Division of Whitesell International Corporation
22100 Trolley Industrial Drive
Taylor, MI 48180-1872
(313) 299-8540

Site Use Policy

Go To Top