FabriSteel Fasten it Drive it
graphic Overview
graphic CP Pierceform Studs
graphic CS Pierceform Studs
graphic Hi-Stress Pierce Nuts
graphic Universal Pierce Nuts
graphic MHN PierceNuts
graphic RSK PierceForm Nuts
graphic RSK PierceForm Nuts
 
 
Pierce Nut Standards  |  Part Design Guidelines  |  MultiPierce Reel-Feed Design Info 
Multimatic Reel-Feed Design Info  |  MultiPierce Bulk-Feed Design Info 
Multimatic Bulk-Feed Design Info  |  Die Buttons and Retainers  |  Maintenance  |  Optional Tooling
Tooling Standards  |  Troubleshooting  |  Tooling Set-Up and Alignment Procedures  

Die Buttons and Retainers

Die Buttons

The Die Button, held firmly in the die by the Retainer, forms the part material into and around the Pierce Nut and undercuts and/or clinches the nut corners to secure it in position.  Additional die buttons, other than those shown below, are available for special applications.  Consult your representative.

Die Buttons

Pierce Nut No. A B
13M610 25.4 mm 23.80 mm
1.00 in. 0.937 in.
50WM610 25.4 mm 23.80 mm
1.00 in. .937 in.
51WM610 25.4 mm 23.80 mm
1.00 in. .937 in.
21WM610 31.75 mm 30.15 mm
1.25 in. 1.187 in.
37WM825 31.75 mm 30.15 mm
1.25 in. 1.187 in.
39WM825 31.75 mm 30.15 mm
1.25 in. 1.187 in
99WM015 38.10 mm 36.49 mm
1.50 in. 1.437 in.
99WM1275 38.10 mm 36.49 mm
1.50 in. 1.437 in.

Die Button Retainers

Die Button Retainers

Retainer Nut Type X Dimension
MPRAM-100 13M610, 50WM610, 51WM610 47.6 mm 1.875 in
HSRBAM-100 12WM610, 13M610, 45WM610, 60AW610 50.8 mm 2.00 in.
MPRAM-125 21WM610, 37WM625, 39WM825 47.6 mm 1.875 in
HSRBAM-125 22WM825, 25WM825, 62WM015, 80AW825 50.8 mm 2.00 in.
HSRBAM-150 20WM1275 50.8 mm 2.00 in.
MPRAM-150 99M1275 47.6 mm 1.875 in

 
 

Home  |  Site Map  |  Search

FabriSteel A Division of Whitesell International Corporation
22100 Trolley Industrial Drive
Taylor, MI  48180-1872
(313) 299-8540

 

This page last modified 06/08/07 .
All information © 2007 Whitesell International Corporation

Site Use Policy

 Go To Top